- Air and Fluid heating solutions
- Renewable energy
- Industry
- Agriculture and Farming
Main applications: Liquid heating when the space available for the heating element is reduced. E.g. heating oil supply systems, oil filters, sump engines, gearboxes, hydraulic power units. The heater has a built-in thermostat. It is the smaller heating element with built-in thermostat.
- 3 surface load values: 2,5W/cm², 5W/cm², 10W/cm². See technical introduction to optimize the surface load.
Heating tube material: Element diameter 10mm, AISI 304 (AISI 316, AISI 321; Incolloy 800, 825 on request).
Insulation: Magnesia compressed by lamination guaranteeing good heat transfer and allows loads up to 20W/cm²Fitting Material: TIG welded 304 stainless steel, with gasket seat. Shipped without gasket.
Thread: M14x1.5
Connection: PVC insulated wires, 300V, 300mm length
Ingress Protection: IP65 wires output, carried out by PA66 over-molding.
Standard lengths(L1): 215, 315, 415, 515, 615mm
Not immersed heating zone (L2): 40mm.
Non-heating zone receiving the thermostat (L3): 50mm
Surface load: 2, 5W/cm² (main applications for oils), 5W/cm² (water without flow), 10W/cm² (circulating water). Other surface loads on request.
Voltage: 220-240V single phase, and 24VDC
Thermostat calibration temperatures: 50 ±5°C (122±9°F), 70 ±5°C (158±9°F), 90 ±5°C (194±9°F), 100 ±5°C (212±9°F), 110 ±5°C (230±9°F)
Options on request (MOQ may apply):
- Other calibration temperature, from 40°C to 150°C (104 to 302°F).
- Types without built-in thermostat
- Lower tolerances on the calibration temperature
- Different wire lengths
- Over-molded cable output
- Tube length up to 1.8m (Maximum power 1700W in 230V and 360W in 24VDC)- Other thread
- Other voltage